Zenner MULTIDATA WR3 Manual do Utilizador descarregar pdf (Página 9)

Symbol Status Maßnahme

Flow existent

Attention! Check system / device for errors

Data transmission

Emergency operation Exchange device

External power supply

Status display / Error codes

The symbols in the table below show the meter’s operational status. The status messages only appear

in the main display (energy)! The temporary display of the warning triangle can be caused by special

operating states and does not always mean that the device is malfunctioning. However, should the symbol

be displayed over a longer period of time you should contact the service company.

Error codes show faults detected by multidata. If more than one error appears, the sum of the error

codes is displayed: Error 1005 = error 1000 and error 5.

Code Error Event

1 Short-circuit return sensor

Check sensors, replace if needed

2 Interruption return sensor

Check sensors, replace if needed

3 Short-circuit supply sensor

Check sensors, replace if needed

4 Interruption supply sensor

Check sensors, replace if needed

5 Hardware error Exchange device

6 Battery empty or wrong temp. sensor Check device / sensor

Temperatures out of measuring range

Correction heating system

100 Emergency operation Exchange device

1000 Battery life time exceeded Exchange device

2000 Initial verication expired Exchange device

> 8000 Internal hardware error Exchange device

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Zenner MULTIDATA WR3 Manual do Utilizador Página 9